Interlogix NX-8E User Manual Instrukcja Użytkownika Pobierz pdf (Strona 12)

CHANGING USER CODES

Step 1 Your system must be in the Disarmed state to change user codes.

Step 2 Press []-[5].

Step 3 Enter a “Master Arm/Disarm Code”.

NOTE: For partitioned systems, someone changing the code of

another person must have access to all or more partitions than

the user being changed.

Step 4 The ready light will flash.

Step 5 Enter the 3-digit “user number”. You must always enter 3 digits,

such as [0] - [0] - [3] for user 3, or [1] - [5] - [2] for user 152.

Step 6 Enter the new four (4) or six (6) digit “user code”.

NOTE: To delete a user code, enter []-[]-[]-[] for a 4-digit code,

or []-[]-[]-[]-[]-[] for a 6-digit code.

Step 7 The ready light will flash indicating you are back at Step 4 above. If

the code is rejected, the sounder will beep 3 times.

Step 8 If another “user code” needs to be programmed, return to Step 5.

Step 9 Press the [#] key while the ready light is flashing to exit the User Code

Programming Mode.

ASSIGNING USER CODE AUTHORITY LEVELS

Assign authority levels to users by following the steps below. Assign user codes

before assigning authority levels.

Step 1 Press []-[6].

Step 2 Enter a “Master Arm/Disarm Code”.

NOTE: Someone changing the authority of another person can

only add or remove partition authorization for partitions to

which they have access.

Step 3 The ready light will flash.

Step 4 Enter the 3-digit “user number” to be assigned authority (The ready

light is constant and the instant light will flash).

Step 5 Lights illuminated indicate the authority levels assigned to this code.

An explanation of the lights is listed below. You may toggle (turn

on/off) the authority level by pressing the number for that authority

level.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Brak uwag

Interlogix NX-8E User Manual Instrukcja Użytkownika Strona 12