Interlogix GE-DSH-73 Series User Manual Instrukcja Użytkownika Pobierz pdf (Strona 31)

Chapter 2: Installation

GE-DSH-73/DSH-82 and DSH-82-PoE User Manual 27

Figure 2-14: Wiring the redundant power inputs

3. Tighten the wire-clamp screws to prevent the wires from coming loose.

Figure 2-15: Wiring the redundant power inputs

1 2 3 4 5 6

Power 2 Power 1

- + - +

NOTE: The wire gauge for the terminal block should be in the range between 12 ~ 24

AWG.

For the GE-DSH-82-PoE, A 48VDC, 3A power input is required for full PoE load on the

PoE. Please connect an external power source to the terminal block that can supply

steady power at 48VDC.

Wiring the Fault Alarm Contact

The fault alarm contacts are in the middle of the terminal block connector as the

picture shows below. Inserting the wires, the Industrial Switch will detect the fault

status of the power failure, or port link failure (available for managed model) and then

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 178 179

Brak uwag

Interlogix GE-DSH-73 Series User Manual Instrukcja Użytkownika Strona 31