Interlogix NS4702-24P-4S-4X Command Line Guide Instrukcja Użytkownika Strona 134

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 434
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 133
-134-
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # poe mode plus
4.2.65.74 poe pdcheck IP
Command:
poe pdcheck IP <ipv4_addr>
poe Power Over Ethernet.
pdcheck Allows user to enable or disable per port PD Alive Check function.
IP To set PoE device IP address here for system making ping to the PoE device.
<ipv4_addr> <ipv4_addr>
Default:
N/A
Usage Guide:
To configure Ping PD IP Address of PoE for specific interface
Example:
To configure Ping PD IP Address (10.101.10.10) of PoE for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # poe pdcheck IP 10.101.10.10
4.2.65.75 poe pdcheck action
Command:
poe pdcheck action { reboot | alarm | reboot-alarm }
poe Power Over Ethernet.
pdcheck Allows user to enable or disable per port PD Alive Check function.
action Allows user to set which action will be applied if the
PD is without any response
alarm It means system will issue an alarm message via Syslog, SMTP.
reboot It means system will reset the PoE port that is connected to the PD.
reboot-alarm It means system will reset the PoE port and issue an alarm message via Syslog, SMTP.
Przeglądanie stron 133
1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 433 434

Komentarze do niniejszej Instrukcji

Brak uwag