Interlogix Monitor XL Advanced Installation Guide Instrukcja Użytkownika Pobierz pdf (Strona 43)

21-3602E rev1.5 Monitor xL™ Advanced Installation Guide 37

Example 7: Simple Two Term OR Equation with Timed Output

Configurable only with Director software and Sent to Panel

Bxxx:0 “? A001.15 Query ”

- Area 1 is not ON

Bxxx:1 “? A002.14 Query ”

- Area 2 is OFF

Bxxx:2 “L 00 Logic ”

- Logical OR operator

– additional screen generated with Director software.

Bxxx:3 “T 012 Timer ”

- Timed output, 2 minutes

–

additional screen generated with Director software.

1. Output Bxxx will turn on for 2 minutes when area 1 changes from on or when area 2 goes off from some other

state.

2. The output will not turn back on again after the 2 minutes expire until area 1 goes On and Area 2 is either STAY or

ON.

3. After these two conditions are met, the output will turn back on as noted in point 1.

Example 8: Flash a LED when a Condition is True

Configurable only with Director software and Sent to Panel using “System – Special Outputs”

Bxxx:0 “? A016.24 Query ”

- A point is bypassed in Area 16

Bxxx:1 “? S001.00 Query ”

- Turns 1 sec On, 1 sec Off

Bxxx:2 “L 01 Logic ”

- Logical AND operator

Bxxx:3 “T 000 Timer ”

- Follow (Normal)

 When a point is bypassed in area 16, the output will flash 1 second on, 1 second off.

 This is achieved by the logical AND of the area condition query and the special On /Off effect available in System –

Special Outputs programming.

Example 9: (Complicated) Flash a LED for 45 Minutes after a Panic Token is Detected in an

Area

Configurable only with Director software and Sent to Panel using “System – Special Outputs”

B001:0 “? A001.47 Query ”

- Panic Token used in Area 1

B001:1 “T 019 Timer ”

- Timed Output, 45 minutes

B002:0 “? S001.00 Query ”

- Turns 1 sec On, 1 sec Off

B002:1 “? B001.00 Query ”

- Output 1 is ON

B002:3 “L 01 Logic ”

- Logical AND operator

B002:4 “T 000 Timer ”

- Follow (Normal)

 2 separate outputs are used to perform this procedure.

 A 45 minute timer is applied to panic tokens detected in area 1 in e.g. output # “B001”.

 The output state of B001 (timed output based on panic token in area 1) is used to logically “AND” additional output #

e.g. B002 with the Special System 1 second On/Off selection. The important detail is that we use Follow (Normal)

for output B002, in order for the timer not to re-trigger.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 75 76

Komentarze do niniejszej Instrukcji

Brak uwag

Interlogix Monitor XL Advanced Installation Guide Instrukcja Użytkownika Strona 43

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Panel sterowania Interlogix Monitor XL Advanced Installation Guide